This is the singular item that I wouldn't tour without!
 
Be sure to order the correct size for your bike. You will need to measure the Contact Point of your bike.
 
The "Contact Point" is the spot where a Click-Stand would touch your bike. Typically that is where the bottom, or underside, of the top tube meets the seat tube. With your bike standing upright (vertical), measure from the "Contact Point" straight down to the ground. Round your measurement to the nearest sixteenth inch, or use millimeters. That measurement is your "Contact Height"
 
We sell teg Max 5 model
Handmade in 
Two models of Click-Stands support all types of bikes, from loaded                             tandems to racing bikes.
Made from expedition/aircraft grade 7000 series aluminum tubing.
The Max's tubing is .433" (11mm) in diameter.
Supports you bike above its center of gravity, which makes it stronger and more stable than a traditional kickstand.
Weighs approximately 75 grams. 
Supports fully-loaded touring bicycles, even loaded tandems pulling a Bob! Tour tested.
Paint friendly rubber coated replaceable cradle.
Non-slip rubber foot.
Lean your bike to either side.
Works on up, down, or side hills just as well as on flat ground.
USA Patent Protected.
A Click-Stand is not to be used with any type of child seat.